How To Make A Honey Bear Bong

How To Make A Honey Bear Bong. Poke a second hole just above the waterline and press a downstem through it so the end inside of the bottle is submerged. This is now the stem of your bong.

Piece of the Week Honey Bear Bong Weedist from www.weedist.com

The 14 best homemade bongs getting your smoke on with style from honestmarijuana.com the key ingredient is heat, and to decarboxylate your weed all you need is to grind some up and. Cut off the bottom 2 inches of the plastic bottle. Finally, light the bowl and poke a small hole in the.

Source: www.weedist.com

Take a ballpoint pen, remove the ink, and that’s the downstem. To make your bong, cut a small hole located about half way down the side of your bottle just big enough for your down stem to fit, then secure in place using electrical tape, hot glue, or silly putty.

Source: www.pinterest.com.mx

Eat a ton of shit with honey on it. Punch a small hole or about 2 inches (5cm) from the bottom of the bottle.

Source: www.pinterest.com

To make a bong, start by filling up a plastic bottle 1/4 of the way with water. All you need is some weed, some sort of stem with a bowl on it and of course, a honey bear.

Source: www.weedist.com

Once heated, quickly make a small incision with the knife. You need an empty honey bear bottle of your favorite honey brand and a squeeze out top for it.

Source: 420bigbud.com

Just follow these 3 simple steps: A honey bear bong is pretty easy to make also.

All You Have To Have Is An Empty Honey Bear Bottle, A Bowl, Which Costs About A Dollar At Any Smoke Shop, 1 Foot Of 3/4 Inch Rubber Hose, Tobacco And A Lighter.

You do this by holding the flame of the lighter against the water bottle, then shoving. *subscribe here to join the dabbasquad an hit that notification bell homies* *find me on social media here*snapchat: Then, fill the bottle with water and secure the foil on the mouthpiece.

Just Follow These 3 Simple Steps:

Now that the honey bear is empty…all you need to do is poke a hole in the bear’s gut and shove that stem thing inside him and…well, you’re done. The 14 best homemade bongs getting your smoke on with style from honestmarijuana.com the key ingredient is heat, and to decarboxylate your weed all you need is to grind some up and. Cut the tubing in half.

Now You Need To Make A Hole In A Honey Bear Bottle For The Downstream With The Slide And A Bowl.

Post comments (atom) sponsored links. Using the lighter (or a match, if you’re in the bathroom), heat the spot on the container where you’d like to place the downstem. To begin with, cut a small bowl out of tin foil and poke a few holes in it with a sharp knife.

Place The Slide And Bowl In Place And Use A Rubber To Seal The Air Leak.

You need an empty honey bear bottle of your favorite honey brand and a squeeze out top for it. The next step in making a homemade bong is to use the lighter to make a small hole in the bottom third of the bottle. Then, poke a hole near the top of the bottle to make a carb.

Fill A Separate, Larger Bottle With Water (This Can Be Any Container As Long As It Is Bigger Than Your Bottle) Take Your Plastic Bottle And Submerge It Open Side Down Into The Water Until.

First you need to be sure most of the honey is out of the bottle but leave about a half inch of it in the bottom. Find a bottle—any plastic bottle should work for a homemade water bong. A honey bear bong is pretty easy to make also.